Hi,
It is reported in a few platforms that the SAU NSC region limit is set 32 bytes larger than expected because the value set did not match the hardware characteristics. The SAU.LADDR treats the last 5 bits as 0x1 which means a valid limit address should be the value with 0x1f in the last bits, take an example if the region starts at 0x1000 with size 0x100, the limit address should be set as 0x1000 + 0x100 - 0x20 which is 0x10E0. The practical region address range is [0x1000 - 0x10FF], all addresses >= 0x1000 and <= 0x10FF would be treated as hitting a region.
If your address and size are 32 bytes aligned already, you can just adjust the limit with "start_address + size - 1", as the tailing 5 bits would be masked. Take this patch as an example: Platform: Fix the Veneer SAU region for Arm platforms (I2692f318) · Gerrit Code Review (trustedfirmware.org)https://review.trustedfirmware.org/c/TF-M/trusted-firmware-m/+/18547
Now only the NSC region is affected, but please check your platform if you are using SAU to see if each region is set properly.
Thanks.
/Ken