Hey RH
Apologies, this has been a known issue for a while (or rather, a series of known issues that we keep fixing).
We've just merged a patch upstream which: * Replaces the function calls with fixed register writes to avoid issues with uninitialized global data * Performs DTCM initialization in all cases, avoiding relying on the DMA ICS or having to check the SP mode
You can find it here https://review.trustedfirmware.org/c/TF-M/trusted-firmware-m/+/40838
Unfortunately we've only been able to test it on the FVP at the moment, which has limited ECC support. If you'd be able to test the patch and let me know if it fixes your issue, that would be appreciated.
Raef
________________________________________ From: 김륜현 via TF-M tf-m@lists.trustedfirmware.org Sent: 24 July 2025 05:38 To: tf-m@lists.trustedfirmware.org Subject: [TF-M] RSE booting with HardFault issue when TRAM enabled
Dear TF-M developers
Hello, i'm developing and porting TF-M our platforms based on RDV3R1.
To enable TRAM, i modified a cmake config file like below(platform/ext/target/arm/rse/common/config.cmake)
- set(RSE_ENABLE_TRAM OFF CACHE BOOL "Whether TRAM encryption is enabled")
+ set(RSE_ENABLE_TRAM ON CACHE BOOL "Whether TRAM encryption is enabled")
First of all, RSE core boots with Virgin CM
In this mode, Secure Provisioning is not enabled so that the DTCM don't be initialized even if TRAM is enabled.
setup_tram_encryption()@startup_rse_bl1_1.c
tram_enable_encryption(&tram_dev_s);
if (sp_enabled == LCM_TRUE && (lcs == LCM_LCS_CM || lcs == LCM_LCS_DM)) {
bl1_trng_generate_random((uint8_t *)&random_word, sizeof(random_word));
for (idx = 0; idx < DTCM_SIZE / sizeof(uint32_t); idx++) {
((uint32_t *)DTCM_BASE_S)[idx] = random_word;
}
}
Because DTCM doesn't be initialized, the next codes which use global variable in BL1_1 data section on DTCM cause hardfault.
So, i applied the workaround by modifying condition like below.
tram_enable_encryption(&tram_dev_s);
- if (sp_enabled == LCM_TRUE && (lcs == LCM_LCS_CM || lcs == LCM_LCS_DM)) {
+ if ((lcs == LCM_LCS_CM || lcs == LCM_LCS_DM)) {
bl1_trng_generate_random((uint8_t *)&random_word, sizeof(random_word));
for (idx = 0; idx < DTCM_SIZE / sizeof(uint32_t); idx++) {
((uint32_t *)DTCM_BASE_S)[idx] = random_word;
}
}
But the global variable in uninitialized DTCM are also used in bl1_trng_generate_random().
So, i tried to initialize DTCM as 0 without calling bl1_trng_generate_random().
But after that, setting SP_ENABLED for CM Provisioning causes warm reset, TRAM is disabled but DTCM doesn't be initialized.
It causes same problem.
I know that enabling TRAM is performed DMA descriptor without RSE_ENABLE_TRAM option, it may also cause the problem because of the phenomenon that TRAM is disabled but DTCM doesn't be initialized when warm reset.
Should i modify let it use local variable? or is there anything to fix this problem?
Best Regards
RH Kim