Hi Raymond,
Here is the proposed fix:
https://review.trustedfirmware.org/c/TF-M/trusted-firmware-m/+/6028
Could you verify on your board? Pls use at build -DCMAKE_BUILD_TYPE=Debug for full logging in bootloader.
Tamas
From: TF-M <tf-m-bounces@lists.trustedfirmware.org>
On Behalf Of Tamas Ban via TF-M
Sent: 01 October 2020 10:37
To: Raymond Ngun <Raymond.Ngun@cypress.com>; tf-m@lists.trustedfirmware.org
Cc: nd <nd@arm.com>
Subject: Re: [TF-M] Musca-B1 and new build system
Hi Raymond,
Thanks for reporting the issue!
The observed behaviour has two reason:
- In the new build system the default CMAKE_BUILD_TYPE=Release. In this case the logging is disabled in MCUboot to get smaller binary. You can set manualy to Debug in the command line to enable logging from bootloader
Tamas
From: TF-M <tf-m-bounces@lists.trustedfirmware.org>
On Behalf Of Raymond Ngun via TF-M
Sent: 30 September 2020 17:44
To: David Hu via TF-M <tf-m@lists.trustedfirmware.org>
Subject: [TF-M] Musca-B1 and new build system
Hi all,
I am attempting to build Musca-B1 with the latest in master but I’m not able to get it to run (nothing shows on the UART). At a minimum, the User Guide is out of date in terms of how the final hex is created. So, I have
a couple questions.
Thank you,
Ray
This message and any attachments may contain confidential information from Cypress or its subsidiaries. If it has been received in error, please advise the sender and immediately delete this message.