Hi Sherry,
Thanks for the explanations.
So if I understood correctly, there is a plan to support then? If so then when?
It is not an issue for us but just want to know to better schedule our work.
Regards,
Bohdan Hunko
Cypress Semiconductor Ukraine
Engineer
CSUKR CSS ICW SW FW
Mobile: +38099 50 19 714
Bohdan.Hunko@infineon.com
From: Sherry Zhang <Sherry.Zhang2@arm.com>
Sent: Friday, December 8, 2023 04:43
To: Hunko Bohdan (CSS ICW SW FW 3) <Bohdan.Hunko@infineon.com>; tf-m@lists.trustedfirmware.org
Cc: nd <nd@arm.com>
Subject: RE: Redundant checks in FWU code
Caution: This e-mail originated outside Infineon Technologies. Do not click on links or open attachments unless you
validate it is safe. |
Hi Bohdan,
FWU is not supported in DIRECT_XIP and RAM_LOAD upgrade strategies. The main reason is that, in FWU, it does not record which slot is the active running slot and always takes the primary slot as the active running slot. In the c source
code, these two upgrade strategies are taken into consideration in component state management to make it easier to support them later in FWU.
Regards,
Sherry Zhang
From: Bohdan.Hunko@infineon.com <Bohdan.Hunko@infineon.com>
Sent: Thursday, December 7, 2023 10:52 PM
To: tf-m@lists.trustedfirmware.org; Sherry Zhang <Sherry.Zhang2@arm.com>
Subject: Redundant checks in FWU code
Hi all,
In config/check_config.cmake there is a following code:
tfm_invalid_config((MCUBOOT_UPGRADE_STRATEGY
STREQUAL
" DIRECT_XIP "
OR
MCUBOOT_UPGRADE_STRATEGY
STREQUAL
"RAM_LOAD")
AND TFM_PARTITION_FIRMWARE_UPDATE)
So looks like FWU is not supported when
DIRECT_XIP or
RAM_LOAD upgrade strategies are used.
But then in FWU code I see a lot of checks for
DIRECT_XIP or
RAM_LOAD, for example in fwu_bootloader_get_image_info:
#if
!defined(MCUBOOT_DIRECT_XIP)
&&
!defined(MCUBOOT_RAM_LOAD)
&&
\
!defined(MCUBOOT_OVERWRITE_ONLY)
What is the point of these checks if it is impossible to compile FWU code with
DIRECT_XIP Because of check in config/check_config.cmake?
Regards,
Bohdan Hunko
Cypress Semiconductor Ukraine
Engineer
CSUKR CSS ICW SW FW
Mobile: +38099 50 19 714
Bohdan.Hunko@infineon.com